Cisco 360 CCIE R&S Advanced Workshop 2 v1.0

מק"ט: #1812 | משך קורס: 40 שעות אק'

The Cisco 360 CCIE R&S Advanced Workshop 2 (CIERS-2) teaches learners how to use an expert-level problem-solving process including options analysis to support complex network technologies and topologies. This course is a second part of a blended learning curriculum that supports expert-level preparation in routing and switching.

הקורס פעיל לקבוצות מטעם ארגונים בלבד, ניתן לשלוח פנייה רק אם מדובר בקבוצה
*שדות חובה
PDF version

קהל יעד

The primary audience for this course is as follows:
• Network engineers that need be able to use an expert-level problem-solving process including options analysis to support complex network technologies and topologies.
The secondary audience for this course is as follows:
• Network designers that design and support complex network technologies and topologies.
 

דרישות קדם

To gain the prerequisite skills and knowledge, learners must have passed the Cisco CCIE Routing and Switching written exam.
Before taking Cisco 360 CCIE R&S Advanced Workshop 2, learners should be very familiar with the topics covered in Cisco 360 CCIE R&S Advanced Workshop 1. It is also strongly recommended that learners perform two self-paced assessment exams before attending this course. Learners should be able to demonstrate advanced-level competencies (knowledge and skills) equivalent to the following:
• Performing expert-level tasks involving Frame Relay and switched Ethernet networks
• Performing expert-level tasks involving RIPv2, EIGRP, and OSPF
• Performing expert-level tasks for route redistribution
• Performing expert-level tasks for BGP
• Performing expert-level tasks for IP multicast
• Performing expert-level tasks for IPv6 unicast connectivity
• Performing expert-level tasks for Router QoS using the MQC
• Performing expert-level tasks for Catalyst 3560 Series QoS
 

מטרות הקורס

• Perform expert-level tasks involving RIP version 2, Enhanced Interior Gateway Routing Protocol (EIGRP), and Open Shortest Path First (OSPF)
• Perform expert-level tasks for route redistribution
• Perform expert-level tasks for Border Gateway Protocol (BGP)
• Perform expert-level tasks for IP multicast
• Perform expert-level tasks for IP version 6 unicast connectivity
• Perform expert-level tasks for router quality of service (QoS) using the Modular QoS CLI (MQC)
• Perform expert-level tasks for Cisco Catalyst 3560 Series QoS
 

נושאי הקורס

Course Introduction: Review the general Cisco 360 problem-solving approach
•  Module 1: Perform the first full-length graded assessment lab and participate in the postexam review and discussion
•  Module 2: Perform the second full-length graded assessment lab and participate in the postexam review and discussion
•  Module 3: Perform the third full-length graded assessment lab and participate in the postexam review and discussion
•  Module 4: Perform the fourth full-length graded assessment lab and participate in the postexam review and discussion
•  Module 5: Perform the final graded assessment lab (4 hours) and participate in the postexam review and discussion

Lab Outline:
•  Module 1: CIERS2-GA-LAB01 (8 hours and 15 topics; level of difficulty: moderate)
•  Module 2: CIERS2-GA-LAB02 (8 hours and 16 topics; level of difficulty: difficult)
•  Module 3: CIERS2-GA-LAB03 (8 hours and 14 topics; level of difficulty: difficult)
•  Module 4: CIERS2-GA-LAB04 (8 hours and 14 topics; level of difficulty: moderate)
•  Module 5: CIERS2-GA-LAB05 (4 hours and 7 topics; level of difficulty: easy)
 

לפי יצרן: 
תגיות